Custom Bathroom Remodeling & Wet-Room Design

Converting a tub into a walk-in shower requires removing the tub unit, re-trenching or adjusting the drain placement (moving from a standard 1.5-inch tub drain to a 2-inch shower drain per code), framing a pre-pitched shower slope, applying a continuous waterproof membrane, tile setting, and fitting frameless glass.

Permits are required whenever a bath project involves re-routing plumbing lines, relocating drain stacks, moving or expanding electrical circuits, or altering structural framing (like removing or expanding walls). Simple fixture-for-fixture replacements without structural or trade shifts typically do not require permits.

We utilize multi-layer membrane waterproofing systems (such as Schluter®-KERDI or liquid-applied hydro-barriers) that cover all walls and shower pan areas. Prior to laying any tile, we perform a mandatory 24-hour static flood test by plugging the drain and filling the basin with water to verify 100% leak-free performance.

Standard drywall is never used in wet zones. We install cementitious backer board or waterproof foam board (like Schluter®-KERDI-BOARD) behind all tiled wet surfaces. For non-tiled bathroom walls, moisture-resistant drywall (greenboard or purple board) is used to prevent humidity damage.

Yes. Electric radiant floor heating mats can be installed directly beneath the tile underlayment. These systems are connected to a dedicated wall thermostat, providing energy-efficient floor warmth during cooler months.